Black Oil for kitchen countertops 0.75 l

WOCA oil for countertops is used for untreated or previously oil treated / abrased wooden surfaces.

- WOCA oil for countertops is FDA approved
- Best protection against dirt and water impact
- Natural and glossy surface
- Accentuates the grit structure of the wood
- Can be used on all wood types

Range: Approx. 12-15 m2/litre depending on the wood type.
Colour: black
Drying time (at 20 degrees): Approx. 24 hours
Tool: Brush or roll

User Guide

How to apply the oil when the wood is untreated:

1. Sand the surface with grit 150 sandpaper. Hoover the countertop to remove any dust from sanding.
2. Clean the surface thoroughly with Wood Cleaner mixed with water in a ratio of 1:20. After cleaning leave the countertop to dry for a minimum of 4 hours at 20 degrees celcius.
3. Carefully stir the oil.
4. Distribute a suitable amount of oil with a brush in an even layer. If possible apply at least one layer of oil to The back of the countertop.
5. Wait for approx.30 minutes at 20 degrees while the oil penetrates the wood. Apply more oil if dry areas appear.
6. Polish longitudinally with a red hand scrubber.
7. Wipe off excess oil with a lint-free cotton cloth. The surface must be completely free from excess oil.
8. Leave the countertop to rest for an hour and repeat steps 4-7.
9. The countertop should be treated 2-3 times before use. During the final treatment sand in the wet oil use sandpaper for wet sanding grit 280-320 before wiping off.
10. The oil is dry enough for use after 24 hours at 20 degrees. During this time the countertop must not be affected by water. The oil is not properly hardened until after approx.1 week and should be handled with care during this period. Spilt liquid must be rapidly wiped off.

How to do when the wood has beenpreviously oil treated:

1. Sand the surface with grit 150 sandpaper. Hoover the countertop to remove any dust from sanding.
2. Carefully clean the surface with Wood cleaner mixed with water in a ratio of 1:20. After cleaning, the countertop is left to dry for a minimum of 8 hours at 20 degrees.
3. Repeat steps 3-10. Refer to the guidelines above for untreated countertops.
4. After 24 hours at 20 degrees the oil is dry for use. During this period the surface must not be affected by water. The oil is not properly hardened until aproximately 1 week later and should be treated with care during this period. Spilt liquid should be immediately removed.

The countertop is maintained as required. WOCA countertop gel or WOCA oil for countertops is recommended. Please refer to "How to do when the wood has previously been oil treated". Use Natural Soap for the daily cleaning or Natural Soap Spray.